|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
December 22nd 05, 12:02 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
Low voltage warning level
Hi All,
I'm looking for recommendations for a low battery warning voltage level. I was going to use 12.8V - is this liable to be triggered by noise/dips in the bus voltage? My guess is when heaters or motors kick in there could be a momentary drop due to high current that could trigger my low voltage indicator. Also it it worth putting a long time constant filter on this? Thanks! Mark. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| terminology questions: turtledeck? cantilever wing? | Ric | Home Built | 2 | September 13th 05 10:39 PM |
| Displaced AFSS "controllers" heading for BIL and GRB | Chip Jones | Instrument Flight Rules | 12 | April 10th 05 10:22 PM |
| Parachute fails to save SR-22 | Capt.Doug | Piloting | 72 | February 10th 05 06:14 AM |
| For Keith Willshaw... | robert arndt | Military Aviation | 253 | July 6th 04 06:18 AM |
| S-TEC 60-2 audio warning | Julian Scarfe | Owning | 7 | March 1st 04 09:11 PM |
Threaded Mode