|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 25th 05, 03:26 AM
|
|||
|
|||
dimpling
When I dimple holes in thin sheet they get larger to the point where the
clecos won't hold. Should I drill holes that are to be dimpled for 1/8 rivets a little smaller (like #31 or #32)? What are others doing? Mike Murphy Moose. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Dimpling and riveting pressures | Max Krippler | Home Built | 5 | November 11th 03 09:03 PM |
Threaded Mode