|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
February 6th 06, 11:09 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
Voltage Standing Wave Ratio Bridge
Following the Jim WEIR article in Kitplanes november 05 issue; I
would like to know,what is the procedure for making a test on my ICOM IC-A 22E hand held transceiver with the VSWR bridge,and an oscilloscope connected to the J3 port. Is that an absolute measurement or a relative one? Thanks for your help and sorry for my english. SUIRE2 
|
|
#2
February 9th 06, 04:10 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
|
Voltage Standing Wave Ratio Bridge
SUIRE2 wrote:
Following the Jim WEIR article in Kitplanes november 05 issue; I would like to know,what is the procedure for making a test on my ICOM IC-A 22E hand held transceiver with the VSWR bridge,and an oscilloscope connected to the J3 port. Is that an absolute measurement or a relative one? Thanks for your help and sorry for my english. SUIRE2 Ah So, you Inglish velly good!
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Normal voltage drop | Robert M. Gary | Piloting | 21 | January 24th 06 04:44 AM |
| Low battery voltage level | markp | Instrument Flight Rules | 8 | December 22nd 05 11:16 AM |
| Early season Sierra Wave flight | [email protected] | Soaring | 1 | September 28th 05 05:50 AM |
| A Sea Story (OT and long) | Mike Kanze | Naval Aviation | 4 | March 14th 05 04:51 AM |
| High Voltage | Jim Rosinski | Piloting | 7 | October 16th 04 11:48 PM |
Linear Mode
