![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
Jack Allison wrote:
Oops...meant to post in r.a.o...bah, stupid fingers! Piper has a new service bulletin, SB1161 that calls for inspection of the rib just inboard of the landing gear and aft of the main spar. http://www.newpiper.com/company/Publ...20Insp-Mod.pdf The SB requires putting the plane on jacks and removing the gear side brace and bracket. As 04T is in for the annual, we figured it was a good time to have the SB performed. It turns out we have cracks on both sides of the rib and they're bad enough that the repair kit announced in the SB can't be used. Solution: two new ribs. Cost for parts: 1.1 AMU. Labor is unknown at the moment but the shop is putting together an estimate. At least I can split the repair bill three ways...but it's still gonna put a dent in the flying funds. -- Jack Allison PP-ASEL-Instrument Airplane Arrow N2104T "When once you have tasted flight, you will forever walk the Earth with your eyes turned skyward, for there you have been, and there you will always long to return" - Leonardo Da Vinci (Remove the obvious from address to reply via e-mail) |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Cracked ribs | Jack Allison | Piloting | 17 | April 1st 06 09:14 AM |
Cracked cylinder: Typical cause? | Peter R. | Owning | 19 | October 9th 04 04:24 AM |
Testing Stick Ribs | Bob Hoover | Home Built | 3 | October 3rd 04 02:30 AM |
Heat treating wing ribs | Holger Stephan | Home Built | 13 | February 3rd 04 11:59 PM |
Is a cracked vent SCAT tube an urgent problem? | Ben Jackson | Owning | 18 | September 20th 03 03:31 AM |