![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
Hello,
I'm trying to identify a hydraulic fitting I don't recognize. Photos and description can be seen online at: http://www.turbinefun.com/Unknown_Hydraulic_Fitting.asp Any help or insight would be greatly appreciated. Thanks! Larry |
#2
|
|||
|
|||
![]()
that power boat looks pretty fast in the
banner section of the page showing your fitting.... |
#3
|
|||
|
|||
![]() "~^ beancounter ~^" wrote in message ups.com... that power boat looks pretty fast in the banner section of the page showing your fitting.... I own a few CDs of clip art (stock photography) and put a few fast boats in a 'rotator' (which loads one at random with the page load). If you like those, you'll love these Offshore Raceboat Crashes: mms://69.93.51.164/pureguts/boats56.wmv (for dialup) and mms://69.93.51.164/pureguts/boats400.wmv (for broadband) Just copy the link into your browser and the movie streams from the server. My boat is the white 30' Cobra Terminator: http://www.turbinefun.com/Fast_Boats.asp (halfway down the page) It's gutted right now as I'm in the middle of converting it to turbine power. I'll keep updating my site as I make progress. Larry |
#4
|
|||
|
|||
![]()
nice....
|
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Help identifying a hydraulic fitting | larry | Rotorcraft | 0 | May 10th 06 07:55 PM |
Help identifying a hydraulic fitting | larry | Restoration | 0 | May 10th 06 07:55 PM |
Help identifying a hydraulic fitting | larry | Home Built | 0 | May 10th 06 07:54 PM |
Need some help identifying an AN fitting | larry | Home Built | 0 | May 7th 05 07:13 AM |
quick disconnect hydraulic fitting | [email protected] | Home Built | 8 | January 7th 05 03:28 PM |