![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
I recently upgraded from an Ipaq 3760 to an Ipaq 3950 series PDA. I
noticed the screen is brighter, but also I am getting more glare in the cockpit. Have others tried the anti-glare screen protectors and do they help? Thanks , Tim |
#2
|
|||
|
|||
![]()
I use the BoxWave on my 3955, and the glare is certainly reduced. You
also get a slight reduction in 'brightness'. Can't have it both ways I guess. And they protect from scratches. Bob |
#3
|
|||
|
|||
![]()
Tim,
I use an Ipaq 3955 with Glide Navigator II. I bought the Ipaq used and it came with a screen protector on it. Since I've never used it without the screen protector, I can't say if it does any good at reducing glare and I'm not even sure if it is supposed to. Now, I'm calling it a 'screen protector' but heck, it might be a 'glare reducer.' It's just a clear plastic overlay stuck onto the screen and I've never attempted to pull it off. In some light, I can see it fine and in others, its a bit of a strain. But I have to say it was the same for my Compaq Aero 1520. Sometimes, I just had to wait a few seconds in the thermal for the sun to be at the right angle so I could easily read the screen. I don't find the Ipaq much different than the older Aero in that regard. I was running PocketNAV on the Aero...very similar to Glide Navigator II in the way it appears on the screen. Ray Lovinggood Carrboro, North Carolina, USA At 18:54 15 May 2006, Ttaylor At Cc.Usu.Edu wrote: I recently upgraded from an Ipaq 3760 to an Ipaq 3950 series PDA. I noticed the screen is brighter, but also I am getting more glare in the cockpit. Have others tried the anti-glare screen protectors and do they help? Thanks , Tim |
#4
|
|||
|
|||
![]()
TTaylor at cc.usu.edu wrote:
I recently upgraded from an Ipaq 3760 to an Ipaq 3950 series PDA. I noticed the screen is brighter, but also I am getting more glare in the cockpit. Have others tried the anti-glare screen protectors and do they help? Actually, some of us would consider that to be a downgrade, for precisely the reason indicated in this post (want to sell your 3760? 8^). Certain anti-glare screen protectors help a bit (I use BoxWave ClearTouch Anti-Glare), but the real problem for many 45+ year old eyes is that the backlighting on transflective displays is just not bright enough to provide adequate contrast in bright sunlight. Reflective displays (like the 3760 has) have better contrast in sunlight, their weakness is in dim lighting, such as being under a dark cloud, or in an office. About the only solution I've come up with is maximizing the contrast on the display, by using a pure white background with black markings. I'm going to try white on black at some point to see if that works better... Marc |
#5
|
|||
|
|||
![]()
I've been using a borrowed Ipaq 3955 which is supposed to have one of the
best screens - actually it's crap unless the sun angle is just right. No LCD screen is fully 'sunlight readable' unless it has a monster backlight that pulls huge amperage. As it is, the 3955 significantly reduced my battery life over my old 1550 that died from a 6" fall. I've been looking at a 12V component computer system running WinXP. There are 6" transflective LCD screens with ultra-bright LED backlights. I'd have to switch on the backlight with a stick grip switch whenever I wanted to see it or carry huge batteries. Just maybe there is hope in new screen technology. Maybe OLED displays will be better outdoors although some reviewers say not. "E-Paper" reflective screens look just like printed paper and take very little power. Unfortunately, neither of these technologies are currently available in a WinCE device you can buy - yet. I'm trying not to buy until something much better is available. Bill "Marc Ramsey" wrote in message ... TTaylor at cc.usu.edu wrote: I recently upgraded from an Ipaq 3760 to an Ipaq 3950 series PDA. I noticed the screen is brighter, but also I am getting more glare in the cockpit. Have others tried the anti-glare screen protectors and do they help? Actually, some of us would consider that to be a downgrade, for precisely the reason indicated in this post (want to sell your 3760? 8^). Certain anti-glare screen protectors help a bit (I use BoxWave ClearTouch Anti-Glare), but the real problem for many 45+ year old eyes is that the backlighting on transflective displays is just not bright enough to provide adequate contrast in bright sunlight. Reflective displays (like the 3760 has) have better contrast in sunlight, their weakness is in dim lighting, such as being under a dark cloud, or in an office. About the only solution I've come up with is maximizing the contrast on the display, by using a pure white background with black markings. I'm going to try white on black at some point to see if that works better... Marc |
#6
|
|||
|
|||
![]() Hi Tim, I use the glare reducer/protector offered by Richard at Craggy Aero and it improves readabilitiy but not enough for me. I often have to eliminate color terrain features (Winpilot) to get better contrast. What has really helped me was to move the Ipaq closer and on a mount where I can rotate it as part of my problem is my polarized sunglasses. Moving it closer has helped a lot. But that is probably because these old eyes now need correction close and far and I wear graduated trifocals now. Oh well! |
#7
|
|||
|
|||
![]()
I am very disappointed with the readability of my HP Ipaq in direct or
near-direct sunlight, although it was reviewed as being one of the brightest. I switched to gradient sunglasses so that the bottom part does not darken the screen so much. As someone else mentioned, the next step is to mount it on a bracket that brings it closer... at a cost of $70-$100. Grumble, grumble... "Bill Daniels" bildan@comcast-dot-net wrote in message ... I've been using a borrowed Ipaq 3955 which is supposed to have one of the best screens - actually it's crap unless the sun angle is just right. No LCD screen is fully 'sunlight readable' unless it has a monster backlight |
#8
|
|||
|
|||
![]()
Thanks for all the replies. I will try one of the anti-glare covers.
The screen brightness is not so much an issue, it is mainly total reflection from inside the canopy. I have it mounted with a RAM mount about 18 inches in front of me on the left side on the canopy rail. Marc I do have the old one as well as a 3670 for sale. I agree, they do have a better screen for use in the glider. Tim |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Tapered Wings and North-Paw Saws | [email protected] | Home Built | 5 | April 8th 06 08:41 PM |
UAV's and TFR's along the Mexico boarder | John Doe | Piloting | 145 | March 31st 06 06:58 PM |
millionaire on the Internet... in weeks! | Malcolm Austin | Soaring | 0 | November 5th 04 11:14 PM |