|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 24th 06, 12:15 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
Grounding metal parts in wooden/composite aircraft
I purchased the RST antenna kit last year (great value) and have a
question relating to grounding all the significant metal parts. I wish to operate an ADF in a wooden/composite aircraft. I note that any wire will do (e.g. tin-plated Cu grounding strap and/or Cu tape). My question is how do you ground all the metal if it's been corrosion-proofed (Alodine, Zinc Chromate + paint or epoxy painted)? Scratch it off and re-paint or leave bare patches during corrosion-proofing. Any suggestions please? Garry O'Leary Horsham, Australia 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Most reliable homebuilt helicopter? | tom pettit | Home Built | 35 | September 29th 05 03:24 PM |
| Homebuilt Aircraft Frequently Asked Questions (FAQ) | Ron Wanttaja | Home Built | 1 | January 2nd 04 10:02 PM |
| Homebuilt Aircraft Frequently Asked Questions (FAQ) | Ron Wanttaja | Home Built | 0 | October 2nd 03 04:07 AM |
| Homebuilt Aircraft Frequently Asked Questions (FAQ) | Ron Wanttaja | Home Built | 4 | August 7th 03 06:12 AM |
| Homebuilt Aircraft Frequently-Asked Questions (FAQ) | Ron Wanttaja | Home Built | 0 | July 4th 03 05:50 PM |
Linear Mode
