|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 1st 06, 05:44 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
misdrilled hole on on tubular aluminum spar question
There's a discussion on a ul ng about a guy that built a strut braced light
plane and in a fit of overkill (apparently ) decided to add a (non plans) jury strut. He drilled a hole (3/16") on the bottom of the tubular alum spar. Then realized he may have made a mistake. Whats the outcome and is there a fix without putting in a new spar. Just curious (and I didn't do it!!) Pat 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Question about Alodine 1201 | Andrew Sarangan | Home Built | 20 | April 11th 06 02:31 PM |
| Tech: Aluminum Forming Question | Scott Rodriguez | Home Built | 5 | March 15th 06 05:42 AM |
| mismatched hole question | Dick | Restoration | 5 | October 17th 04 01:43 PM |
| epoxy aircraft seats? | Lpmcatee356 | Home Built | 26 | December 4th 03 12:16 AM |
| DuoDiscus Wing | Duane Eisenbeiss | Soaring | 27 | October 31st 03 03:34 AM |
Threaded Mode