|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
February 25th 07, 06:21 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
Rustproofing Steel
On Feb 24, 4:28 pm, "Kyle Boatright" wrote:
Our EAA chapter had a fabric covering seminar today, so of course, we got off-topic very quickly and delved into the issue of keeping 4130 structures from corroding, even in a fairly short timeframe after surface rust has been blasted or sanded away but before priming. Is there any reason not to use a phosphate conversion coating immediately after cleaning up the steel? Would this protect it for a week (or a month) before the steel was primed? KB A product that works great for this is Rustlick 631. http://www1.mscdirect.com/CGI/NNSRIT...MT4NO=18687474 Several aircraft manufactures use it. After the steel cools to room temp, wire brush and spray it on. Colin http://www.jumprunenterprises.com 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rustproofing Steel | J.Kahn | Home Built | 0 | February 25th 07 03:44 AM |
| 4130 steel tubing? | TJ400 | Home Built | 2 | May 30th 06 10:21 PM |
| Steel Axles | Alan & Ruth Glatt | Home Built | 0 | December 13th 05 01:59 AM |
| IS the US out of 4130 Steel? | mallakka | Owning | 0 | April 21st 04 11:48 AM |
| steel 4130 | Philippe Vessaire | Home Built | 4 | October 19th 03 08:19 AM |
Hybrid Mode
