|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 19th 03, 06:22 PM
|
|||
|
|||
Non TSO'd IFR indicator
The Garmin 430 GPS/COM/GS/VOR/LOC requires an external CDI for the non
GPS NAV. The Michel MC-60 digital CDI http://www.avionix.com/indicator.html fits the Garmin 430 but is not TSO'd. Does the CDI have to be certified for IFR use in experimentals? 
|
|
#2
September 19th 03, 07:00 PM
|
|||
|
|||
|
Where is the phrase "certified for IFR use" defined or the requirement listed?
Jim (Paul Lee) shared these priceless pearls of wisdom: Does the CDI have to be certified -for IFR use Jim Weir (A&P/IA, CFI, & other good alphabet soup) VP Eng RST Pres. Cyberchapter EAA Tech. Counselor http://www.rst-engr.com
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Refurbishing indicator guage faceplates | Merle Wagner | Home Built | 2 | August 20th 03 05:18 AM |
| Cloud Height Indicator | Bob Bristow | Home Built | 0 | August 11th 03 07:42 AM |
Linear Mode
