|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
July 6th 08, 11:32 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
superfil used before or during fiberglass layup?
I have a few foam gaps to fill. I can apply superfil early on and let
it cure...or I can wait and apply while i am laying up with fiberglass skin (w/vacuum, etc.) . which is better? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Fiberglass vs. Fabric | Lou | Home Built | 35 | July 6th 06 05:08 PM |
| Aluminized fiberglass | Dan, U.S. Air Force, retired | Home Built | 2 | May 3rd 05 08:35 AM |
| In Contemplation While Doing a Wet Layup on a Plastic Homebuilt Airplane | jls | Home Built | 3 | August 17th 04 09:38 PM |
| Carbon Fiber Layup - Conformal Peel Ply? | RKT | Home Built | 4 | February 29th 04 02:33 PM |
| question: differences between epoxy layup and plaster | Morgans | Home Built | 3 | August 6th 03 04:46 AM |
Threaded Mode