|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
April 1st 09, 05:13 AM
posted to rec.aviation.soaring
|
|||
|
|||
bolt not coming undone on asw-15b mainwheel
Trying to change the tube out. There's 3 small 10 mm nuts on one
side. One of them came right off no problem. The other two, turn, but the bolts spin with the nut! The backside of the bolt is inside the wheel. The only one that came off, was just easy to unscrew. If I can't reach inside and hold the backside of the bolt, then how can I get these three bolts off to change the tire? If anyone has done this, and I can send pictures to your email....then shoot me a line at "liv2soar at yahoo dot com" Thermals are here! See you at cloudbase Spam 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Grob 103 AD note for bolt, USA | [email protected] | Soaring | 2 | March 2nd 09 05:47 PM |
| Tost brake bolt shears off | Jack Glendening[_2_] | Soaring | 25 | September 10th 07 10:15 PM |
| Bolt Head markings | john smith | Piloting | 2 | June 13th 05 02:23 AM |
| Bolt torque | Neal Fulco | Home Built | 1 | October 16th 04 06:57 AM |
| Prop bolt torque setting | Whunicut | Home Built | 2 | September 4th 03 12:12 PM |
Threaded Mode