|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 11th 03, 01:39 AM
|
|||
|
|||
Propeller question
I'm building a Lancair 360 with the Mattituck IOF-360 engine. Any
suggestions on a good constant speed propeller to go with this setup? 
|
|
#2
October 11th 03, 03:36 AM
|
|||
|
|||
|
In article , "John
Nicholson" writes: I'm building a Lancair 360 with the Mattituck IOF-360 engine. Any suggestions on a good constant speed propeller to go with this setup? If money is not a big issue, I would go with the MT prop using either the electric or standard govenor. Bob Reed www.kisbuild.r-a-reed-assoc.com (KIS Builders Site) KIS Cruiser in progress...Slow but steady progress.... "Ladies and Gentlemen, take my advice, pull down your pants and Slide on the Ice!" (M.A.S.H. Sidney Freedman)
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| MT MTV-9-B-C/C190 Propeller for Sale - Pitts N5351N.jpg (0/1) | Chris Nehls | Aerobatics | 2 | December 19th 04 05:38 AM |
| Tailwheel question | Steve B | Aerobatics | 4 | January 30th 04 03:35 AM |
| propeller calculation and how to build | jgarner | Home Built | 7 | August 25th 03 03:23 AM |
| Question on Pulsejets/Ramjets??? | DarylG1532 | Home Built | 3 | August 16th 03 03:20 AM |
| Propeller | Jan Carlsson | Home Built | 11 | July 12th 03 10:36 PM |
Linear Mode
