|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
March 24th 09, 12:15 AM
posted to rec.aviation.soaring
|
|||
|
|||
Bending Plexiglass
I need to make a new section of the canopy on the Cherokee. Its a pretty
simple bend, not really a compound curve or anything. But I dont know anything about how to do it. I suspect that I need to heat the plexi up and then weight it to bend, repeat as necessary? Im sure that several of us have been there done that. Looking forward to ideas. Thanks! -Tony Condon Cherokee II N373Y 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Bending Plexiglass | Tony Condon[_2_] | Soaring | 12 | March 25th 09 06:18 PM |
| Plexiglass problem | Klettke | Home Built | 4 | July 31st 07 09:57 PM |
| Plexiglass problem | TerryJ | Home Built | 2 | July 30th 07 03:07 AM |
| Plexiglass Glue | Jim Vincent | Soaring | 6 | March 23rd 07 08:25 PM |
| Bonding Plexiglass | David Melby Cavalier | Home Built | 5 | November 21st 06 12:20 AM |
Threaded Mode