|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 14th 03, 05:53 PM
|
|||
|
|||
Marske spar workshop
Spar design and Construction workshop with Jim Marske.
Saturday and Sunday november 22 and 23, 2003. Cost $250 Topics covered: Introduction to Carbon rods and their properties compared to wood, aluminum and fiberglass Hand layup rovings compared to Carbon rods General construction techniques of a carbon rod spar Work the math for calculating the number of rods requried Use the computer spreadsheet for calculating spars for individual projects Mold construction for spars Build a sample spar Spar testing How to test a wing and the math behind it Film on the testing of the Genesis spar testing to destruction -mat -- Marske Flying Wings http://www.continuo.com/marske 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| FS: Wing spar angle extrusions | Bob Kuykendall | Home Built | 0 | September 25th 03 09:23 PM |
| Carbon Spar design and construction workshop | Marske Flying Wings | Home Built | 0 | September 18th 03 06:47 PM |
Threaded Mode