|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
November 8th 03, 03:05 PM
|
|||
|
|||
KT-76A transponder is flakey
My KT-76A transponder stops working after an hour or so of use. If I pull
it out, it feels very hot to the touch. I was thinking of buying another transponder off ebay. Can I just slide mine out and another in myself ? What other transponders are pin and slide-in compatible ? Thanks ! Peter N1447U 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| VHF & Transponder antenna | Steve | Home Built | 1 | December 6th 04 04:29 PM |
| Fixing the Transponder with Duct Tape and Aluminum Foil | Ron Wanttaja | Home Built | 45 | March 14th 04 12:18 AM |
| WTB: Mode C Transponder | Chris Batcheller | Aviation Marketplace | 0 | February 21st 04 01:31 PM |
| Altimeter And Transponder Certifications - Dallas | Dave | Aviation Marketplace | 0 | September 20th 03 03:55 PM |
| transponder check? | Russell Duffy | Home Built | 10 | August 14th 03 11:36 PM |
Threaded Mode