|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
July 5th 11, 03:38 PM
posted to rec.aviation.soaring
|
|||
|
|||
Bell No-Mor Flats in Tailwheel
Has anyone tried using the "Bell No-Mor Flats" foam rubber material in a
tail wheel tire as a safety backup. It looks like the 1.75" diameter cut to the correct length might be a good safety backup if the tail wheel tire gets punctured. 9U 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Tailwheel ID | R. Mueller | Aviation Marketplace | 2 | February 5th 08 11:25 PM |
| tailwheel | [email protected] | Soaring | 6 | December 16th 06 01:46 PM |
| wanted scott 3200 tailwheel /alaskan bushwheel tailwheel | phillip9 | Aviation Marketplace | 0 | June 6th 06 08:57 PM |
| First Tailwheel!! | W P Dixon | Piloting | 9 | May 9th 05 10:07 PM |
| Looking for an L-23 tailwheel | Alex Zobell | Soaring | 0 | October 31st 03 08:19 PM |
Threaded Mode