|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 28th 11, 06:12 PM
posted to rec.aviation.soaring
|
|||
|
|||
ASK-21 control surface seals
Our club (SLSA) just acquired a nice "pre-owned" ASK-21. It doesn't
have any external seals (tape) on the ailerons and elevator. Is this worth doing, like on the G-103? Also, do any ASK-21 operators remove the main gear fairing when operation off grass? Bit of an argument developing in the club about this... ;^) Cheers, Kirk 66 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Control surface design question | Chris W | Home Built | 16 | July 30th 07 05:17 AM |
| Labelle control surface weights | Martin Eiler | Soaring | 1 | April 28th 07 01:32 AM |
| Control surface repair legal? Part II | [email protected] | Owning | 8 | October 10th 06 05:31 AM |
| Control surface repair legal? | [email protected] | Owning | 10 | September 25th 06 08:51 AM |
| Control surface alignment | [email protected] | Home Built | 10 | July 4th 05 11:06 PM |
Threaded Mode