![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
My Cherokee is in the paint shop, due out in a few weeks. Looking for
suggestions on maintaining a new Imron finish... Of course, I will solicit input from the paintshop as well. The plane is hangared, and only sits outside when on trips, so I figure that is a good start. Many people do not recommend washing/waxing new paint for several months (to allow full curing). Is this required? I fly IFR. Need I be concerned about flying into rain or keeping the plane out of rain until it is 'fully cured'? How about taking bugs off the leading edge? |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
VA Health Care | Steve Mellenthin | Military Aviation | 0 | August 19th 04 05:45 PM |
Good Paint Remover? | Marco Leon | Owning | 2 | June 22nd 04 07:58 PM |
The State of the Union, Health care and more lies from the President | George Z. Bush | Military Aviation | 15 | June 14th 04 05:56 AM |
Radar Absorbing Paint | robert arndt | Military Aviation | 2 | December 2nd 03 05:09 PM |
Choice of Paint for use over Copper foil Antennas | Charlie Precourt | Home Built | 1 | December 2nd 03 02:51 AM |