![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
In an update to an earlier post "Decision time - Our partnership decided to
sell our '77 Warrior II while it still had about 400 hrs left before TBO....." The oil analysis came back and it didn't show any glaring problems so we have decided to keep it and fly it on through TBO. Since we are going to keep it for a while, we need to get it painted. Murmer is down here by us at AXH but they are pricey. I can't see putting a 12K paint job on a 35K plane. There are a few shops in Mena, AR that have offered some pretty good quotes. Does anybody have any experience with them? I'm looking for recommendations or horror stories about paint shops in the area. Anywhere within about 600nm of Houston is reasonably local. Thanks, Ed N40008 |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
One coat paint for aluminum? | [email protected] | Home Built | 10 | September 17th 04 07:01 AM |
Good Paint Remover? | Marco Leon | Owning | 2 | June 22nd 04 07:58 PM |
Cheap paint job | Paul Folbrecht | Owning | 26 | April 7th 04 08:35 PM |
Radar Absorbing Paint | robert arndt | Military Aviation | 2 | December 2nd 03 05:09 PM |
Choice of Paint for use over Copper foil Antennas | Charlie Precourt | Home Built | 1 | December 2nd 03 02:51 AM |