|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
January 22nd 04, 03:06 AM
|
|||
|
|||
Jim Weir's Capacitive Fuel Gauge
I read with keen interest the articles on Jim's capacitive fuel gauge
and want to build two. Has anyone made available a printed circuit board for it? Where could I get one or two? Lastly, does nyone have any cheap circuits for a tachometer? Thanks Dave 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Fuel Drip Containment | Sven | Home Built | 28 | October 27th 03 10:28 PM |
| Yo! Fuel Tank! | Veeduber | Home Built | 15 | October 25th 03 02:57 AM |
| Pumping fuel backwards through an electric fuel pump | Greg Reid | Home Built | 15 | October 7th 03 07:09 PM |
| Fuel pressure Problems | smf | Home Built | 3 | September 7th 03 08:25 PM |
| Question ~ Does fuel injection add weight? | Barnyard BOb -- | Home Built | 0 | July 6th 03 09:47 PM |
Threaded Mode