|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
January 20th 04, 04:03 PM
|
|||
|
|||
Sheet metal "Nibbler"
Any thoughts on "Nibblers. Pneumatic Vs Electric?
Does anyone have experience with the electric Rodman Sheet-metal Cutting head? Said to cut mild steel, 16 gage. Bob Gaines Marietta, GA 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Right prop, wrong prop? Wood prop, metal prop? | Gus Rasch | Aerobatics | 1 | February 14th 08 10:18 PM |
| Cutting sheet steel | Ernest Christley | Home Built | 28 | November 28th 03 06:58 PM |
| New JAR-VLA certified all metal basic trainer and quick build KIT plane. | marcin | Home Built | 0 | October 13th 03 12:32 PM |
| Sheet metal shear/press brake | VideoFlyer | Home Built | 7 | October 7th 03 07:08 PM |
| DK-1 All Metal single seat biplane | Michael | Home Built | 0 | July 28th 03 05:16 PM |
Threaded Mode