Removing Old Tape

I have some cloth type tape sealing the ailerons of my Elfe S3. I'm
pretty sure the tape is restricting the ailerons from reaching maximum
deflection, and it needs to be replaced anyways.

Any ideas for the best way to get this stuff off?

Thanks

2C

On Mar 26, 3:31*pm, Kevin Christner wrote:
I have some cloth type tape sealing the ailerons of my Elfe S3. *I'm
pretty sure the tape is restricting the ailerons from reaching maximum
deflection, and it needs to be replaced anyways.

Any ideas for the best way to get this stuff off?

Thanks

2C

Heat often helps. Hair dryer is probably easiest/safest. Most PSA
adhesives on tapes we use become much easier to deal with at about
120F.

T8

But if there is a solvent in your future... Naptha solvent (cigarette
lighter fuel) is said to be safest on glider finishes. However,
Xylene solvent (major ingredient in 3M Adhesive Remover) usually works
the best on most adhesives; normally better than Naptha or Acetone.

GW

On Mar 26, 2:15*pm, Steve Koerner wrote:
But if there is a solvent in your future... Naptha solvent (cigarette
lighter fuel) is said to be safest on glider finishes. * However,
Xylene solvent (major ingredient in 3M Adhesive Remover) usually works
the best on most adhesives; normally better than Naptha or Acetone.

GW

Goo Gone Extreme works well.

http://hpd.nlm.nih.gov/cgi-bin/house...ds&id=13009030

Mike

At 19:31 26 March 2012, Kevin Christner wrote:
I have some cloth type tape sealing the ailerons of my Elfe S3.
I'm
pretty sure the tape is restricting the ailerons from reaching
maximum
deflection, and it needs to be replaced anyways.

Any ideas for the best way to get this stuff off?

Thanks

2C


Add generously carnauba wax, and then put plastic on top of it so
that the solvents of the wax cannot dissolve, but soften the glue.

On Mar 26, 3:40*pm, Kimmo Hytoenen wrote:
At 19:31 26 March 2012, Kevin Christner wrote:

I have some cloth type tape sealing the ailerons of my Elfe S3.
I'm
pretty sure the tape is restricting the ailerons from reaching
maximum
deflection, and it needs to be replaced anyways.

Any ideas for the best way to get this stuff off?

Thanks

2C

Add generously carnauba wax, and then put plastic on top of it so
that the solvents of the wax cannot dissolve, but soften the glue.

I've been removing the mylar and double sided tape dimple zig zag off
of the DG wings. I made a mix of acetone and 3M adhesive remover an
old toothbrush and it works like a champ, can't smoke while you're
doing it.