![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
On Sunday, returning from a flight, I pulled the wing dump lever in my
LAK-17a (the tail tank was already dumping) and it didn't feel like both valves opened. I carried some extra speed through the landing and, after stopping, the left wing went down. A friend on the ground later confirmed that only the right wing was dumping. The wings were full (about 24 gallons on each side) but the LAK handled it beautifully. My point in writing is that I'd used chapstick to seal/lubricate the dump valves and, while sealing quite well, it also glued the valves shut. It took both hands pushing up on the valve from under the wing to get the stuck valve to open. Today I cleaned both valves and seats completely of chapstick and applied a very light coating of bee's wax on the sealing surface of the valves. They work great now (for now)... YMMV, but I'll never again use chapstick on my dump valves. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
VALVES More is Better | [email protected] | Home Built | 8 | January 13th 09 05:34 PM |
LS8 water valves | Bela[_2_] | Soaring | 3 | June 30th 08 03:48 AM |
Water, water, everywhere, but none for thirsty wings.... | Chris OCallaghan | Soaring | 0 | November 21st 04 03:14 PM |
Schemp Hirth water ballast dump valves | tango4 | Soaring | 14 | September 2nd 04 07:13 PM |
Water dump valve rotary seal | Bill Daniels | Soaring | 6 | May 10th 04 11:02 AM |