|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
May 7th 13, 12:57 PM
posted to rec.aviation.soaring
|
|||
|
|||
OAT on LX-7000
Probably a dumb question... and I think I know the answer... but...
May I cut the OAT wires and insert a two-pin connector so that I may place the OAT sensor in a good location in my ship and still easily remove the panel? Looking at the schematics, it's just 2 wires leading to the sensor, so I would think it's okay, but my knowledge of electronics is rather limited (and I'm rather ham-fisted). TIA, John 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Will buy: LX 7000, LX7007 or LX8000 | Erich | Soaring | 0 | December 6th 09 10:54 AM |
| LX 7000 igc pro to winpilot | Stuart Kinnear | Soaring | 7 | May 4th 05 02:29 PM |
| how to homebrew a 7000-psi mechanical press? | Brian Whatcott | Home Built | 0 | April 23rd 05 07:39 PM |
| FS : GPS Trimble TLN 2000 + Moving Map ARGUS 7000 | PA34 F-GFTF | Aviation Marketplace | 0 | January 9th 05 08:42 PM |
| Ilec SN 10 or LX 7000 | Dave Kuchenbecker | Soaring | 12 | October 23rd 03 05:05 AM |
Threaded Mode