|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 9th 13, 04:16 PM
posted to rec.aviation.soaring
|
|||
|
|||
PowerFlarm Updates
Hi Gang
I have just updated the firmware on my PowerFlarm portable unit in the Phoenix without problems to version 3.31. Now how do you do the same for the brick and Butterfly display in the DG1001M? I have loaded the new firmware onto a USB memory stick and plugged it in but the unit does not seem to recognize the memory stick. So I must be doing something wrong. Would someone please show me the correct procedure to update the brick's firmware. Thanks.. Dave 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| PowerFLARM USB 3 cables and ConnectMe to PowerFLARM through V7 | Tim Taylor | Soaring | 20 | June 17th 13 05:56 PM |
| PowerFLARM News Updates on my FLARM web page | Paul Remde | Soaring | 10 | March 6th 13 04:50 AM |
| PowerFLARM updates and installation notes | Dave Nadler | Soaring | 66 | June 7th 12 09:10 PM |
| PowerFLARM Brick and PowerFLARM Remote Display Manuals Available | Paul Remde | Soaring | 30 | May 25th 12 11:58 PM |
| More Updates | Maple1 | Aviation Photos | 0 | November 4th 07 10:29 PM |
Threaded Mode