|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
February 12th 05, 11:59 PM
|
|||
|
|||
Dzus Rail Source
I need some dzus rails, both flat and angle, and need to locate a cheap
source. Any suggestions? Dan, U.S. Air Force, retired 
|
|
#2
February 13th 05, 02:31 PM
|
|||
|
|||
|
Dan, U.S. Air Force, retired wrote: I need some dzus rails, both flat and angle, and need to locate a cheap source. Any suggestions? Dan, U.S. Air Force, retired Sounds like a D I Y project to me .
|
|
#3
February 13th 05, 05:40 PM
|
|||
|
|||
|
Last year, we bought a few 5' dzus angles for $125 each from "East Coast
Aviation Inc". If I were shopping for my plane, I would call a salvage yard. Dan, U.S. Air Force, retired wrote: I need some dzus rails, both flat and angle, and need to locate a cheap source. Any suggestions? Dan, U.S. Air Force, retired -- J Kimmel www.metalinnovations.com "Cuius testiculos habes, habeas cardia et cerebellum." - When you have their full attention in your grip, their hearts and minds will follow.
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| "C-175 SoCal Beware" Original Poster Replies | Bill Berle | Aviation Marketplace | 8 | July 8th 04 07:01 AM |
| A Remote Compass- java source | [email protected] | General Aviation | 0 | July 3rd 04 06:39 PM |
| 4130 sheet source | Leon McAtee | Home Built | 7 | May 2nd 04 08:29 PM |
| Source for copper crush gaskets??? | Jim | Home Built | 2 | August 22nd 03 09:44 PM |
| Source for copper crush gaskets??? | Jim | Owning | 0 | August 22nd 03 06:31 PM |
Hybrid Mode
