![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
Hello All,
The manufacturer of the alternators in the Cessna 310 that I fly requires the pilot to turn off the alternators before engine shutdown. Failure to do this will void the warranty on the alternators. Does anyone know of a reason for this? I have a suspicion that it has to do with the fact that with one engine shutdown, the alternator's field on that engine can be energized by the other engine's alternator. This may cause problems if the battery is low (i.e reverse bias some diodes/transistors). That's just a WAG. Any ideas? -Ali |
#2
|
|||
|
|||
![]()
"Ali Ghorashi" wrote in message ...
Hello All, The manufacturer of the alternators in the Cessna 310 that I fly requires the pilot to turn off the alternators before engine shutdown. Failure to do this will void the warranty on the alternators. Does anyone know of a reason for this? I have a suspicion that it has to do with the fact that with one engine shutdown, the alternator's field on that engine can be energized by the other engine's alternator. This may cause problems if the battery is low (i.e reverse bias some diodes/transistors). That's just a WAG. Any ideas? -Ali The alternator's field current is controlled by the regulator, and when it's on but not turning the field gets pretty much full battery voltage. That voltage would be a bit higher than normal if the other alternator is running, but not dangerously so. The field can take it. The danger, as I see it, is either that the field of the alternator on the dead engine can get hot after a while if it's not spinning and could burn out (the fan isn't cooling it) or that the pilot may forget to make sure the alterators are off before starting the engines next time. Two fields can suck up enough current to make starting an engine that much harder. Dan |
#3
|
|||
|
|||
![]() |
#4
|
|||
|
|||
![]()
The fields cannot cause a problem during startup since the alternators are
turned on after the engine starts. -Ali "Dan Thomas" wrote in message m... "Ali Ghorashi" wrote in message ... Hello All, The manufacturer of the alternators in the Cessna 310 that I fly requires the pilot to turn off the alternators before engine shutdown. Failure to do this will void the warranty on the alternators. Does anyone know of a reason for this? I have a suspicion that it has to do with the fact that with one engine shutdown, the alternator's field on that engine can be energized by the other engine's alternator. This may cause problems if the battery is low (i.e reverse bias some diodes/transistors). That's just a WAG. Any ideas? -Ali The alternator's field current is controlled by the regulator, and when it's on but not turning the field gets pretty much full battery voltage. That voltage would be a bit higher than normal if the other alternator is running, but not dangerously so. The field can take it. The danger, as I see it, is either that the field of the alternator on the dead engine can get hot after a while if it's not spinning and could burn out (the fan isn't cooling it) or that the pilot may forget to make sure the alterators are off before starting the engines next time. Two fields can suck up enough current to make starting an engine that much harder. Dan |
#5
|
|||
|
|||
![]() |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Engines and Reliability | Dylan Smith | Piloting | 13 | June 30th 04 03:27 PM |
Proposals for air breathing hypersonic craft. I | Robert Clark | Military Aviation | 2 | May 26th 04 06:42 PM |
Emergency Procedures | RD | Piloting | 13 | April 11th 04 08:25 PM |
Shutting down engine Question | Lisa | Piloting | 26 | April 5th 04 12:53 AM |
Corky's engine choice | Corky Scott | Home Built | 39 | August 8th 03 04:29 AM |