|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
April 29th 04, 04:25 PM
|
|||
|
|||
Press fit numbers?
Does anyone know what "press fit 1,2 or 3" is? And the differences. This
relates to tension difference in putting a bolt through a hole. Thats all I know about it. I was told to do a "press fit 3". What do I do to meet that spec? Larry 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Any Canadians Who Can Provide Numbers on a Champ, Taylorcraft, or Luscombe with Warp Drive Propeller? | Larry Smith | Home Built | 7 | December 21st 03 09:39 PM |
| Darpa contract numbers | - = krusty = - | Home Built | 9 | July 23rd 03 03:22 AM |
Threaded Mode