|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
March 30th 04, 07:14 PM
|
|||
|
|||
Headsets - Dave Clerk
Going to lash out any buy the Dave Clerk H10-56HXL/XP headset.....intend to
use it in a few machines (Hughes, Bell)...is there anything I need to be aware of in terms of compatibility - impedance issues, NATO connectors versus US connectors etc....which may stop me using an expensive purchase on differient machines? -S 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| My Bose headsets are shocking me! | Peter R. | Owning | 5 | February 17th 04 01:16 PM |
| PIREP: Headsets Inc conversion of Dave Clark DC10-13.4s | Paul Tomblin | Piloting | 0 | January 20th 04 01:46 PM |
| ANR Headsets suitable for heli pilots in training? | Kill Bill | Rotorcraft | 6 | September 16th 03 02:17 AM |
| Searching info about headsets | Mad Mark [P.E. #65] | Home Built | 1 | July 24th 03 08:44 PM |
Threaded Mode