![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
Hello, on the GMAX 4 plane formation of the Red Arrrows from flightsim, does
any one know how to make all of the animations work? The .doc readme wont run on my PC for some reason. I have figures out the Shift+E makes them split apart. And the / make the the two side wingman roll and that F5 through F8 positions them. Does anyone know how to make these extra animations work? Thanks Trace Lewis |
#2
|
|||
|
|||
![]()
This page may help you.
The commands and a picture of the result is listed he http://www.swiremariners.com/redsgmax.html Just scroll down the page past the installation instructions to the "Red Arrows Animated Formation" section. Talon "Tlewis95" wrote in message ... Hello, on the GMAX 4 plane formation of the Red Arrrows from flightsim, does any one know how to make all of the animations work? The .doc readme wont run on my PC for some reason. I have figures out the Shift+E makes them split apart. And the / make the the two side wingman roll and that F5 through F8 positions them. Does anyone know how to make these extra animations work? Thanks Trace Lewis |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Flight of two, IFR | Doug | Instrument Flight Rules | 21 | January 13th 20 01:12 PM |
Six aboard USS Kitty Hawk injured in F/A 18 landing accident | Otis Willie | Naval Aviation | 0 | January 31st 05 10:50 PM |
missing man formation for Reagan | Paul Hirose | Military Aviation | 1 | June 14th 04 12:50 AM |
Kitty Hawk Tickets? | [email protected] | Aviation Marketplace | 0 | November 7th 03 03:20 AM |
Arming Global Hawk Draws Conflicting Comments From Pentagon | Larry Dighera | Military Aviation | 5 | July 14th 03 08:51 PM |