![]() |
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
|
Quilljar
As promised I have prepared a webpage illustrating the two routes for 2D panels using the Parhelia - Please note that both require some work on them. Where a Virtual cockpit is supplied with the aircraft, then that is the preferred route: but this can be difficult in phases of flying such as the landing where the instruments need to be scanned, operations by the mouse needed as well as a good view outside where pheripheral vision is valuable. I would welcome any comments. Warren http://www.cityontheweb.co.uk/aircraft/panel-design.htm |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| WTB: first-class seats and interior panels from airliner | dt | Aviation Marketplace | 0 | August 23rd 04 11:01 PM |
| Glass panels: what OS? | Bruce Horn | Piloting | 84 | June 28th 04 09:31 AM |
| Wrinkly flat panels | [email protected] | Home Built | 27 | March 6th 04 03:12 PM |
| FSCOF 2d panels gone | Mongo | Simulators | 10 | August 3rd 03 01:07 AM |
| Black panels in FS2004 with all of the detonator drivers | Brad D. | Simulators | 0 | August 2nd 03 12:59 AM |