![]() |
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
|
I did a modest cross country in the Pioneer IId yesterday but what is most
interesting was that I am exploring all of the flight envelope and yesterday was stalls. When I pulled the stick all the way back slowly I suddenly found that my airspeed had fallen to zero where I held it for quite some time and my sink rate was 100 down. And I have it on video! I did this many times although there was tendency to turn to the left since we have a left turn in the glider. The airspeed system was calibrated recently, both the airspeed instrument and the installation, however I did not do the calibration for zero airspeed... so it could be off slightly. I have posted a picture on the web site showing the airspeed near zero and will post a video shortly. http://www.continuo.com/marske/pione...%20pioneer.htm This is rather a long address so if this does not work go to our web site and find "Marske Pioneer IId" -mat I have been recording all of this on video to give some credibillity to my claims. -- Marske Flying Wings http://www.continuo.com/marske |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| AOPA Stall/Spin Study -- Stowell's Review (8,000 words) | Rich Stowell | Aerobatics | 28 | January 2nd 09 03:26 PM |
| VP-II wings available in Oregon, USA (Or, "How I was coconuted...") | Roberto Waltman | Home Built | 2 | October 29th 04 05:21 PM |
| Charging for Wings safety seminar? | Marty Shapiro | Piloting | 19 | June 23rd 04 06:28 PM |
| Stolen "Champ" wings located...from 23,000 feet!! | Tom Pappano | Piloting | 17 | December 15th 03 02:24 PM |
| Stall resistant 172? | Roger Long | Piloting | 19 | October 19th 03 12:48 AM |