|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
March 24th 16, 09:17 PM
posted to rec.aviation.soaring
|
|||
|
|||
Gelcoat Sanding
So after attending Uncle Hank's presentation at the convention I have been
inspired to sand out the crazing in my gel coat. I am planning on the 600-1000-1200-1500 wet sanding process and then buffing out the finish. I understand the basics, but does anyone have a good primer on the process? Thanks Peter 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Dry vs. wet sanding | [email protected] | Soaring | 16 | February 19th 16 12:28 PM |
| Gel coat removal - water sanding vs. straight line sanding | LS3 Pilot | Soaring | 45 | February 15th 10 04:32 PM |
| Advice on sanding fibreglass | [email protected] | Home Built | 12 | April 28th 05 11:39 PM |
| Sanding composites | [email protected] | Home Built | 12 | January 31st 05 07:47 AM |
| Fear of Sanding | Stuart Grant | Soaring | 7 | January 17th 05 06:28 PM |
Threaded Mode