|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
July 29th 16, 10:27 AM
posted to rec.aviation.soaring
|
|||
|
|||
Trailer surface preparation
My plan is to remove patches of algae embedded in the GRP surface before
painting. So far, i`ve rubbed/cleaned down the surface as much as I can using wire brush and glasspaper. Any ideas on the most effective product to use please? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Falcon 9 1st stage tank being wrapped in preparation for shipment to the Cape 081203 installing_tarp.jpg | J3 | Aviation Photos | 0 | December 24th 08 12:19 AM |
| F-1 engines being stored in the F-1 Engine Preparation Shop 6521185.jpg | [email protected] | Aviation Photos | 0 | April 9th 07 02:40 PM |
| pre-IFR training/preparation? | Jonathan Sorger | Piloting | 17 | February 7th 05 06:15 AM |
| Spangdahlem-based fighter squadron performs 3-week exercise in preparation for deployment | Otis Willie | Military Aviation | 0 | July 4th 04 12:19 AM |
| Cadet interview preparation | Goyan | Piloting | 0 | May 17th 04 11:54 PM |
Threaded Mode