|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 22nd 16, 10:03 AM
posted to rec.aviation.soaring
|
|||
|
|||
Cambridge 302/Oudie
Every time I declare a task from See You running on an Oudie to my
Cambridge 302 it changes the settings in the 302 to metric. Anyone else had this problem? Thanks Dave 
|
|
#2
August 23rd 16, 06:19 PM
posted to rec.aviation.soaring
|
|||
|
|||
|
Cambridge 302/Oudie
I did have in a previous glider an Oudie 1 and then 2 connected to a 302 and never saw this happen. But I never used this combination of devices to declare a task so my next comments may be rather dumb questions.
Have you checked the Oudie is not set to metric? I have to assume not but had to be asked. I also assume your 302 has been upgraded for the GPS issue (http://aviation.derosaweb.net/cambridge) - but this might not have anything to do with your issue. Two generic ideas. 1) Use the http://naviter.com web site's forum to ask the question. 2) Contact Cambridge to see if they know anything. Sorry to not be more helpful. Good luck
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Oudie to Cambridge | HGXC[_2_] | Soaring | 19 | May 4th 16 08:35 AM |
| Oudie 2 to Cambridge 302 | [email protected] | Soaring | 1 | April 19th 16 05:09 AM |
| WTB: 57mm Cambridge Vario/FS: 80mm Cambridge Vario | ufmechanic | Soaring | 0 | March 24th 09 05:31 PM |
| Cambridge 302 & PDA -- Value of adding Cambridge 303? | V1 | Soaring | 5 | July 31st 07 03:51 AM |
| Cambridge 302/Cambridge 3UTIQ255 utility/ WinPilot/iPAQ 4155 | Nathan Whelchel | Soaring | 4 | July 5th 04 11:22 PM |
Linear Mode
