|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
July 21st 16, 12:31 AM
posted to rec.aviation.soaring
|
|||
|
|||
Boost PowerFLARM Range with Better Antenna?
Have seen lots of comments about where and how to mount PowerFLARM antennas.. Any stories of the effect of changing the TYPE of antenna used: e.g., from (in my case) the short, stubby Portable PowerFLARM rod antenna to, say, the center-fed dipole that comes with the core?
The question is with regard to the FLARM antenna only (not ADS-B or GPS), and specifically on its effect on receive range. Primarily interested in commercial-off-the-shelf components but have built various antennas in the past and not averse to doing so again. Thx. Chip Bearden ASW 24 "JB" 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| PowerFlarm range tool | Mark628CA | Soaring | 2 | November 17th 15 06:24 AM |
| PowerFlarm: 2.7 Vertical Range | [email protected] | Soaring | 8 | April 10th 13 12:27 AM |
| PowerFlarm Range Analysis | Richard[_9_] | Soaring | 0 | March 25th 13 05:43 PM |
| PowerFlarm BRICK range issues - are we alone???? | Mark | Soaring | 79 | October 17th 12 01:17 PM |
| PowerFLarm expected range | [email protected] | Soaring | 6 | August 30th 12 04:43 PM |
Threaded Mode