|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
May 25th 04, 11:16 PM
|
|||
|
|||
gps-nav to ipaq 3600 data and power
I have a gps nav. I have a serial sync cable for my Ipaq 3630. I have
made a connector cable for the gps-nav to the sync cable. I am getting data transfer. Power is through the 8 pin on the db9 on the gpsnav. Can anyone confirm the pin to receive 5 volt power on the db9 sync cable? Also if 5 volts is supplied through the serial cable will the yellow light blink? Rich 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| homemade EFIS system and EMI | jcpearce | Home Built | 75 | February 22nd 05 03:07 AM |
| Pirep: Garmin GPSMAP 296 versus 295. (very long) | Jon Woellhaf | Piloting | 12 | September 5th 04 12:55 AM |
| LOP operation | Roger Long | Piloting | 35 | April 17th 04 06:29 AM |
| Ipaq - GPS_Log Help needed (Long) | Steve B | Soaring | 1 | September 27th 03 07:00 AM |
| iPAQ h2210/h2215 Review | Paul Remde | Soaring | 0 | September 3rd 03 04:45 AM |
Threaded Mode