|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
July 14th 04, 02:33 PM
|
|||
|
|||
Removing JB Weld?
The oil tank o this particular A-65 has a small leak near the
mounting flange. The owner has repeatedly applied JB Weld in an effort to stop the leak, but without much sucess. So we are going to try brazing the thing, but first have to remove a pound or so of stickum. Any suggestions on what NOT to do??? Richard 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Is JB Weld electrically conductive? | Scott | Home Built | 14 | July 12th 04 11:24 PM |
| JB Weld or Hi Temp RTV silicone oil crack fix. | Paul Lee | Home Built | 7 | July 12th 04 03:12 PM |
| What is best "JB Weld" type epoxy putty? | [email protected] | Home Built | 4 | March 8th 04 07:45 AM |
| Tube Cluster Weld Question | Dick | Home Built | 6 | January 17th 04 12:10 AM |
| Removing Aerothane | Yosimite Sam | Home Built | 1 | October 18th 03 03:30 PM |
Threaded Mode