LS 8A Aileron Removal

**svelusive** · January 26th 19, 12:45 AM posted to rec.aviation.soaring

According to the LS 8 Manual to remove the ailerons you loosen the 10mm nut on the fixed bearing #3. I can't see any way to get a wrench, socket into the nut. Is there a special tool required?

**[email protected]** · January 26th 19, 04:06 AM posted to rec.aviation.soaring

Easy answer is to take a 10mm open-end wrench, then grind it down until it will slip in there. Probably only get 1/8th turn per stroke!
JJ

**[email protected]** · January 26th 19, 04:46 PM posted to rec.aviation.soaring

On Friday, January 25, 2019 at 9:06:26 PM UTC-6, wrote:
Easy answer is to take a 10mm open-end wrench, then grind it down until it will slip in there. Probably only get 1/8th turn per stroke!
JJ

Yes you will need to do what JJ said. Took me 6 trips to the grinder to get the wrench ground down enough and even then it was only about 1/8th turn per stroke.

Also had to do the same to a socket to get the rudder nut off.

Tony

**svelusive** · January 26th 19, 05:49 PM posted to rec.aviation.soaring

Thanks guys!
It sure is great having this resource. Saves a lot of time, energy and stress.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Gel coat removal - is this okay?!?	Kevin Christner	Soaring	13	July 10th 15 04:44 PM
Rust removal?	noel.wade	Soaring	22	March 2nd 09 07:22 AM
Adhesive removal	[email protected]	Soaring	8	May 2nd 06 03:37 PM
PA28 140 starter removal	George Hamilton	Owning	2	October 31st 04 06:07 PM
Radio Removal	MRQB	Owning	14	March 25th 04 12:30 AM