|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
May 19th 19, 06:11 PM
posted to rec.aviation.soaring
|
|||
|
|||
LS3A flap/aileron mixer
I am doing an annual inspection on a LS3A and have some concerns regarding the flap/aileron mixer. Just wondering if anybody has any knowledge on proper rigging procedures for this. I have the maintenance manual but it does not address this issue. All I get out of the manual is the deflections and tolerances for the ailerons in a given flap position. I am hoping that there are rigging pins for this but I just don't know. Any help would be appreciated.
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rolladen- Schneider LS3A flap seals- Do they really make any difference? | [email protected] | Soaring | 0 | April 8th 18 06:44 AM |
| Rolladen- Schneider LS3A flap seals- Do they really make anydifference? | Dan Marotta | Soaring | 0 | February 19th 18 05:39 PM |
| Rolladen- Schneider LS3A flap seals- Do they really make any difference? | [email protected] | Soaring | 9 | February 19th 18 02:50 AM |
| FA: M18B Dromader Flap & Aileron | BFC | Aviation Marketplace | 0 | September 24th 04 05:29 PM |
| Flap/aileron don't line up -- always a problem? | Ben Jackson | Owning | 4 | April 13th 04 02:53 AM |
Threaded Mode