![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
In article ,
Bart D. Hull wrote: Jim et al. [[.. el muncho strikes again ..]] #5 Is it a "old wives tale" that you must not run coax next to each other or you will create problems. How else am I going to run the Coax from the back of the plane to the back of the radios? One of the 'et al' responds: Coax comes in various 'grades'. Having to do, among other things, with how 'solid' the "shield" (outer) conductor is. Using the "good stuff" -- 100% shielded -- you can put multiple runs immediately adjacent without creating problems. That aside, the interference from one line to another decreases as the _square_ of the distance between them. two lines run immediately adjacent might have 1/4" between the two center conductors. Put them 'merely' 6" apart, and you've reduced things by a factor of about 600. |
Thread Tools | |
Display Modes | |
|
|