|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
March 22nd 05, 04:26 PM
|
|||
|
|||
Removing Symtec Preheater
Hello -
Our Symtec pan heater has bit the big one, and we need a replacement. Unfortunately, the model we have is prior to them implementing the feature where you can detach a replaceable element from the mounting plate. And the mounting plate is secured to the block with some thermally conductive 'JB Weld' looking stuff that looks pretty stout. How much of a PITA is it to remove the mounting plate? Has anyone had the opportunity to do this? TIA - -- Ben C-172 - N13258 @ 87Y 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Removing cherokee wings.. | pho | Home Built | 9 | February 26th 05 07:10 PM |
| Engine PreHeater In The Plane | [email protected] | Owning | 4 | February 24th 05 03:59 PM |
| Engine Preheater - any good? | Bob Chilcoat | Owning | 26 | January 31st 05 02:58 PM |
| Removing old antennas | Jay Honeck | Owning | 30 | March 21st 04 04:34 PM |
| Preheater | Tony Roberts | Owning | 64 | December 2nd 03 01:47 AM |
Threaded Mode