![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
To all...
I have to fly into AGC (Pittsburgh, PA) this weekend. It's been several years since I've been there. I remember the last time I flew IFR out of there heading east, my clearance was really weird and long (like "intercept the 257 radial off the XXX VOR then...bla-bla-bla) Apparently this is standard operating procedure at AGC but I thought it was long and hard to copy and it took awhile to figure it out. Could somebody out there tell me exactly what the clearance is so I can be ready for it this time? Also, what is Corporate Air like? Is there a better choice? I need a Rent-a-car. Thanks, DB Please remove "removethis" from my e-mail. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Ten Years of Flying | Jay Honeck | Piloting | 20 | February 19th 05 02:05 PM |
Newbie Qs on stalls and spins | Ramapriya | Piloting | 72 | November 23rd 04 04:05 AM |
TSA rule 49 CFR Part 1552 (or its misinterpretation) is already preventing people from flying (even renters) (long) | Bay Aviator | Piloting | 15 | October 21st 04 10:29 PM |
Routine Aviation Career | Guy Alcala | Military Aviation | 0 | September 26th 04 12:33 AM |
Flying and the New Family | Marco Leon | Piloting | 33 | December 24th 03 06:11 PM |