|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
April 17th 05, 05:41 PM
|
|||
|
|||
Garmin 430 user waypoints question
Is there a simple way to program the Garmin to handle in-flight route
instructions such as : "Pass 10 miles N of XYZ at 10,000 ft" or "Continue inbound to ABC, then the 131 radial to DEF..." I can make user waypoints, but it seems a little slow and awkward, especially in hard IFR. Any tricks? Thanks, Michael 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need help with Garmin 196 data transfer (long) | RNR | Piloting | 7 | March 17th 05 07:37 AM |
| Question on Garmin GNC 250XL | Ron | Home Built | 1 | October 24th 04 08:26 AM |
| Garmin gpsmap 76s, glide ratio, airspace zone | Gilles_Sauvagnat | Soaring | 11 | April 15th 04 12:39 AM |
| WAAS and Garmin 430/530 | DoodyButch | Owning | 23 | October 13th 03 04:06 AM |
| FS2004 Garmin GPS map question | Charon | Simulators | 1 | July 28th 03 06:39 PM |
Threaded Mode