|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 25th 20, 01:27 PM
posted to rec.aviation.soaring
|
|||
|
|||
Pawnee aluminum nose tank
I am curious if anyone out there has a Pawnee with an aluminum nose tank? One of the Pawnee’s I work on has one. It was done with a one time STC. (Volunteer Boeing engineers) Also does anyone have issues with the fiberglass tank leaking?
|
|
#2
August 27th 20, 12:31 PM
posted to rec.aviation.soaring
|
|||
|
|||
|
Pawnee aluminum nose tank
On Tuesday, August 25, 2020 at 8:27:35 AM UTC-4, wrote:
I am curious if anyone out there has a Pawnee with an aluminum nose tank? One of the Pawnee’s I work on has one. It was done with a one time STC. (Volunteer Boeing engineers) Also does anyone have issues with the fiberglass tank leaking? I have mo issues with the fiberglass tanks on my Pawnee's. I have seen a aluminum tank that was approved with a 337. The tank was done by Aerial Banners from Ft. Lauderdale. Basically it is a 70 gallon custom built fuel tank that is mounted near where the hopper was. It is impressive and the ability to carry an increased fuel load serves them well.
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Pawnee Fuel Tank Question | Larry Ruggiero | Soaring | 4 | August 18th 18 03:46 AM |
| Pawnee Center Fuel Tank Conversion | [email protected] | Soaring | 8 | May 19th 13 01:48 PM |
| Pawnee fuel tank vent drip | Mike McCarron[_2_] | Soaring | 1 | November 3rd 08 01:56 AM |
| Pawnee D left wing tank needed in Salida, CO | Birdbones | Soaring | 1 | May 21st 08 09:01 PM |
| Building a fiberglass fuel tank and using aluminum fittings? | [email protected] | Home Built | 6 | February 8th 07 05:10 AM |
Linear Mode
