|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
May 26th 05, 02:43 AM
|
|||
|
|||
Thinning paint
I recently tried to touch up the paint on my Maule. The paint went on
fine and seemed ok. I flew yesterday in IMC and rain. Most of the touch up eroded away in under four hours of flying. The factory paint is ok. I thinned the paint 50/50 with VM/Naptha. It flowed and stuck ok. Any suggestions on another thinner that would make the finished product harder? Would a heat lamp after partial drying help? Michelle 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Instrument Panel Paint | [email protected] | Owning | 0 | May 1st 05 02:54 PM |
| Trailer paint removal | Chris Davison | Soaring | 13 | September 3rd 04 10:42 PM |
| Good Paint Remover? | Marco Leon | Owning | 2 | June 22nd 04 07:58 PM |
| Radar Absorbing Paint | robert arndt | Military Aviation | 2 | December 2nd 03 05:09 PM |
| Choice of Paint for use over Copper foil Antennas | Charlie Precourt | Home Built | 1 | December 2nd 03 02:51 AM |
Threaded Mode