|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
February 18th 05, 12:50 AM
|
|||
|
|||
Looking for weird igniter plug
The manufacturer is EYQUEM (French) and the p/n is LCS50 (could also be
3526). email me if you have one (bd5 at bd5 dot com) 
|
|
#2
February 24th 05, 03:55 PM
|
|||
|
|||
|
Well, so much for this one. It's been out of production since 1975. ECET in
France now owns the rights to the EYQUEM aviation product line (Beru AG has the automotive rights), and they are not planning to reintroduce the product unless there is enough demand to justify the cost of the production run. Fortunately, Champion has a very close equivalent that only requires slight machining of the mounting flange for my application... "Juan Jimenez" wrote in message ... The manufacturer is EYQUEM (French) and the p/n is LCS50 (could also be 3526). email me if you have one (bd5 at bd5 dot com)
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Spark plug question for Archie | John S | Home Built | 0 | February 17th 05 06:56 PM |
| Pilot/Owner Signoff for spark plug maintenance? | John Clonts | Owning | 3 | September 14th 04 11:08 AM |
| Helicopter headset plug - help needed | NewsGroups | Home Built | 4 | September 8th 04 05:21 PM |
| wiring a mic plug | S Green | Owning | 2 | February 8th 04 11:28 PM |
Linear Mode
