|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
February 1st 05, 03:40 PM
|
|||
|
|||
Citabria 7ECA Exhaust Wanted
Hi
Citabria with a Lycoming 0-235, Homebuilt. I need an exhaust system similar to an RV4's including heat muffs. I don't know if an 0-320 has the same exhaust as an 0-235. Apparently the crossover option is a must for horsepower, and the intake tubes and carb location are different than the 320. Any help appreciated. Thanks Dave 
|
|
#2
February 2nd 05, 04:23 AM
|
|||
|
|||
|
You could buy it from American Champion in Rochester,
Wisconsin, or from Acorn Welding in Edmonton, Alberta, Canada. Dan
|
|
#3
February 2nd 05, 05:20 AM
|
|||
|
|||
|
Or from Acorn Welding in Edmonton, Alberta, Canada.
I bet these guys are really good. Think how hard it must be to weld acorns, without overheating them! Grinning, Ducking and Running -- Jim in NC
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| The Meredith Effect | Corky Scott | Home Built | 19 | September 4th 04 05:01 PM |
| Exhaust Tape | RobertR237 | Home Built | 19 | July 30th 03 04:06 AM |
Linear Mode
