|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
March 7th 06, 07:05 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
Emron over Ceconite process
I'm looking at a wing that I've been told has been painted with Emron
paint over the Ceconite process. Has anyone any experience with this combo? Any problems? If I had to make a patch would the Emron come off as easily as the dope? - Mike 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Ceconite Wings Question | Captain Wubba | Owning | 14 | October 15th 04 08:55 PM |
| Ceconite v. Poly Fiber - Is one better than another?? | DPB | Restoration | 4 | May 17th 04 07:29 AM |
| Process for Italian Air Force (SAR) | peter pan | Military Aviation | 0 | February 21st 04 09:44 AM |
| Student invents new math process | Otis Willie | Military Aviation | 29 | December 2nd 03 03:13 AM |
Threaded Mode